D324 1 d m6 2 d 1 d H7 r62 d 1 d G7 k62 d 10 14 +0,018 0 12 18 13 19 +0,021 0 14 20 15 21 16 22 20 30 25 35 +0,025 0 30 40 31,5 40 35 45 40 50 45 55 +0,030 0 50 60 55 65 60 75 63 75 70 85 +0,035 0 75 90 80 100 90 110 100 120 120 140 +0,040 0 2052.70.1) / 2086.70. / 2085.72. 8 12 +0,024 +0,006 +0,018 0 10 14/15 12 18 13 19 +0,028 +0,007 +0,021 0 14 20 15 21 16 22 18/19 24/25 20 26/28/30 25 32/33/35 +0,034 +0,009 +0,025 0 28 38 30 38/40/42 31,5 40 32 42 35 44/45 38 48 40 50 40 55 +0,040 +0,010 +0,030 0 45 55/56/60 50 60/62/65 55 70 60 74/75 63 75 65 80 70 85/90 +0,047 +0,012 +0,035 0 75 90/95 80 96/100 85 100 90 110 100 120 110 130 +0,054 +0,014 +0,040 0 120 140 125 145 130 150 140 160 150 170 160 180 2085.70. 12 16 +0,024 +0,006 16 20 +0,028 +0,007 20 26 24 30 2085.71. ASSEMBLY OF GUIDE ELEMENTS DIMENSIONAL REQUIREMENTS AND TOLERANCES Pillar-Ø d1 Retaining bore d2 Tolerance d2 H7 Pillar-Ø d1 Retaining bore d2 Tolerance d2 H7 Pillar-Ø d1 Retaining bore d2 Slip-Fit Bonding Tolerance d2 G7 transition fit Tolerance d2 H7 2052.70. 1) / 2086.70. / 2085.72. Guide bush / Guide bush with collar, Bronze with solid lubricant Slip-Fit Bonding*: Retaining bore d2 = G7 transition fit: Retaining bore d2 = H7 1) if required secure with set screw 2085.71. Guide bush with collar, Bronze with solid lubricant press fit Pillar-Ø d1 Retaining bore d2 G7 Tolerance d2 G7 2085.70. Guide bush with collar, Bronze with solid lubricant transition fit *Slip-Fit Bonding: The glue-line gap must not be smaller than 0,005 mm, or the adhesive will be wiped off the contact surfaces upon fitment. This would result in an unreliable bond. The available component tolerances do not always result in the minimum glue-line gap. This fact has to be born in mind when machining receiving bores, mor alternatively corrections can be made on the assembly bench.
RkJQdWJsaXNoZXIy MTIwNzY0