F88 SETTING-UP BUMPER, SQUARE ø20 ø8,5 e b a 40 60 100 25 252.7. f max. The setting up bumper is located in the storage hole while the toll is in use (guide screw 244.5.13.040 withdrawn). Description: Setting up bumpers are used for setting down and setting up tools and replace shear pins. Material: FIBROFLEX® Hardness 95 Shore A Attention: Setting up bumpers are not suitable for continuous use. To prevent damage when setting down tools, ensure that the setting up bumpers are large enough to withstand 1.5 times the weight of the tool (see table). Implementation: 1. When setting up slowly move the ram into the bottom position. 2. Clamp the tool, then move the ram back to the top position (with the setting up bumper compressed to a height of 60 mm). 3. After setting up, remove the setting up bumpers and place them in the storage hole on the tool. 60 100 Tool set down Spacer block Tool tted Downward stroke Mounting example Admissible tool weight Load capacity in kg for in daN bei 4 setting up bumpers Order No a b e f=20 f=20/safety factor 1,5 252.7.080.060 80 60 36 2,700 7,100 252.7.100.080 100 80 50 6,200 16,500 252.7.125.100 125 100 60 8,600 22,900 252.7.180.100 180 100 100 13,600 36,200 252.7. Setting-up bumper, square
RkJQdWJsaXNoZXIy MTIwNzY0